Insight

Why are rice and pulses picked over and washed?

The two short steps before cooking get mixed up. Once you know what each one is looking for, both the order and how to do them become clear.

Published: 15 September 2026

Before going into the pot, dried pulses and rice can go through two steps: first they are spread on a tray and picked over, then they are washed. The two steps get mixed up, but they look for different things. Picking over targets foreign bits found by eye; washing targets dust on the surface.

What does picking over look for?

What picking over looks for is not the grain itself but what has got mixed in among the grains: small bits of stone and soil, remains of stalks and husks, grains that look darkened or damaged.

A stone does not change with cooking and can end up under a tooth in the cooked dish without being noticed. That is why picking over is done before cooking; after the pot, there is no way left to separate out this piece.

With a packaged product, this look is also a short job. Even if the product is sold cleaned, spreading it on a tray once shows whether anything has got mixed in.

How is it picked over?

The most practical method is to spread the product in a thin layer on a wide tray or plate. The colour of the surface is chosen to suit the product: a dark piece is easier to pick out on a pale surface, and a pale piece on a dark one.

The product is worked through not all at once but a handful at a time: the part pulled to one side has been checked, the rest has not. That way the same spot is not checked twice, and no spot is skipped.

For small-grained products such as lentils and bulgur, the layer is kept thinner. With large-grained chickpeas and beans, darkened, broken or holed grains are also separated out at this point.

What does washing change?

Washing removes dust and crumbs from the surface of the grain. That is why the first water comes out cloudy; washing until the water runs clear shows that nothing is left on the surface to wash off.

With rice, some of the cloudiness comes from starch on the surface of the grain. That is why rice is washed or soaked for pilafs where the grains are meant to stay separate; in recipes where a creamy texture is wanted, the recipe states this step separately.

When red lentils are washed, the water both clouds and foams; the foam is poured off with the water. Pulses to be soaked, such as chickpeas, beans and barbunya (borlotti beans), are washed before soaking; the soaking itself is a separate step.

Why does the order matter?

First they are picked over, then washed. Dry grains slide easily on the tray and the bits between them are visible; wet grains stick together and foreign bits stay between them.

Washing itself does not replace picking over. A stone is heavier than the grain and sinks to the bottom of the water, but it comes into the colander along with the grains; it is not assumed to go away with the washing water.

Picking over is done once, washing just before cooking. Picking over the whole pack in one go and putting it in a jar makes getting out a tray at every cooking unnecessary.

How are washed grains stored?

Washed grains are cooked that day. Rice or pulses put into a jar after washing without being dried carry moisture into the jar; this is exactly what is avoided in storing dry food. The German Federal Institute for Risk Assessment writes that mould spores are carried by the air and settle and multiply when they find a suitable temperature, pH and moisture level on a food; in a closed jar, the only one of these three you can change is moisture. The same institute says that mould does not stay only on the surface but can also spread into the product — which is why the decision is not "picking out the mouldy grains" but never letting moisture in.

If preparation is done in bulk, what is done in advance is picking over, not washing. The picked-over product goes into the jar dry; washing waits for the day it is to be cooked.

Writing a short note to that effect on the jar of picked-over product also helps. Of two jars on the same shelf, which one has been over the tray is not left to guesswork when it is opened.

Can a step be skipped?

If the pack says the product can be cooked without washing, that information is binding for that product. If it does not, the default is to do both steps.

With products used by soaking, such as fine bulgur, washing and soaking can be combined in the same water. Follow however the recipe orders these steps; picking over, however, never takes the place of soaking in any recipe.

The only step that cannot be skipped is looking. A tray of a few seconds separates out, before cooking, a bit that cannot be searched for in the pot.

The conditions for mould on this page are taken from the German Federal Institute for Risk Assessment's page on mould in food; the sentences about picking over on a tray, the washing water running clear and the loss of starch are not measured in the Food Library but are practical arrangements read from the way the job itself works.

Personal decisions on amounts and restrictions linked to a health condition are discussed with a dietitian and a doctor. This content is prepared to support general nutrition literacy; it does not replace medical diagnosis or treatment.

Share:

General information notice. This content is prepared to support general nutrition literacy; it does not replace medical diagnosis or treatment and is not personal nutrition advice. A plan tailored to you can only be prepared by a licensed dietitian; if you are pregnant, have a chronic condition, take regular medication, are feeding a child, or have a clinical condition, a physician and dietitian check is required before starting a plan.

Find a Dietitian